Ball Shooter Internal Spring (Medium-High Strength)
$0.99 each | 
Flipper End-of-Stroke Switch w/Bend (Data East / Sega / Stern)
$4.99 each | 
Car License Plate Frame
$5.00 each | 
WhoDunnit (Bally) Cabinet Tech. Chart - Hard-Laminated
| 
Kings of Steel (Bally) Game ROM Chip U2 (2532 EPROM)
|
Coil Plunger w/ Notch - 2-1/8 Inch (USED)
$4.00 each | 
Playfield Insert Lens - 3/4 Inch Round White Translucent w/ Black 7 (USED)
$3.00 each | 
470-ohm Resistor - 10-Watt - Ceramic
$1.29 each | 
300 (Gottlieb) Rubber Ring Kit
| 
2N6427 Transistor
$0.59 each |
Slingshot Kicker Arm - Offset - Left (Bally/Williams)
$19.53 each | 
15K-ohm Resistor - 1/4-Watt Carbon Film 5% Tolerance
$0.25 each |
Ball Shooter Internal Spring (Low Strength)
$1.09 each | 
Plunger With Nylon Tip 3-9/16 Inch (Data East/Sega/Stern)
$17.59 each | 
Williams Solid-State Flipper Maintenance Manual 16P-487-100 - July 1979
|
Getaway (Williams) Promotional Plastic
| 
Relay Snubber Board Assy - 24 Volt (Data East/Sega/Stern)
| 
Screw - #4-40 x 1/4-Inch Torx Button Head (Black)
| 
Microswitch with Blade Actuator
$7.95 each | 
Ball Shooter Shaft w/ Pointed Knob - Original - 8-7/16 Inches (Bally) (SEE NOTE)
|
Roll Pin - 3/32 x 1/2 Inch
| 
Pop Bumper Cap - Red Starburst w/ Red Lettering - 100 (Bally)
$10.09 each | 
X-Men LE / Premium (Stern) Software Updates
| 
Extra Ball Button Assembly - Yellow (Bally/Williams)
| 
Bad Cats (Williams) Milk Bottle Drop Target Decal Set - 3pcs
$5.00 set |
Pinball Parts
