|
Mounting Tape- Backglass Trim:
Price: $5.99 each
Status: In Stock
(3 Available)
Part #: BGTAPE
Condition: New
|
|
|
Adhesive fabric friction mounting tape used to hold backglass trim pieces to the glass on older vintage games. Can also be used on newer games. This 20 foot roll will do multiple backglasses, and can be cut to length as needed. Most glasses use two 4- to 6-inch pieces per edge. Tape can be doubled-up to increase thickness if needed. Each installed piece wraps lengthwise over the edge of the glass, and the trim piece is then pushed over the glass edge, and is held secure by the tape. A must for replacing old trim with new, and should be used anytime you're installing a new or replacement backglass.
Roll - tape measures 3/4-inch wide x 240 inches long (18mm x 6,09m).
Typically used on games with silkscreened backglasses only (instead of those with Mylar translites). Can be used with translites if necessary.
Ask a question about this item
Used In The Following Games:
BALLY: Aladdin's Castle, Blackjack, Evel Knievel, Fathom, Flash Gordon, Lost World, Mata Hari, Medusa, Night Rider, Paragon, Strikes and Spares, Xenon, more
WILLIAMS: Algar, Alien Poker, Barracora, Black Knight, Black Knight 2000, Blackout, Comet, Contact, Cosmic Gunfight, Cyclone, Defender, Disco Fever, Earthshaker!, Firepower, Firepower II, Flash, Gorgar, Grand Lizard, Hot Tip, Jungle Lord, Lucky Seven, Pharaoh, Phoenix, Solar Fire, Space Shuttle, Time Fantasy, Time Warp, Tri Zone, Warlok, World Cup Soccer, more
|
Pinball Parts
